LINSN TS802 LED Sending Card Cascade Solution

LINSN TS802 LED Sending Card Cascade For High Definition LED Solution

1.Hardware Prepare:

2.Hareware Connection:

1.) Connect the 2 pcs of linsn led TS802D Sending Card by 10 PIN Cable:

Connect linsn led TS802D Sending Card

2). There has 2 RED Botton on the LED Sending Card, One set to 1, Another set to 2:

Set LED Sending Card

3. Install the 2 pcs of Sending Card to PCI interface or SB-8 led sending box, Connect the DVI

Graphic Card with LED Sending Card/LED Sending Box:

Graphic Card with LED Sending Card

3. Software Setup:

2 pcs of TS802 Sending Card Loading Ability is: 1600*1200 dots, There has 4 pcs of RJ45 Signal Output On the LED Sending Card, we named 1U1D2U2D, The RED BOTTON set for 1, we define 1U1D, Another We define 2U2D.

1U1D 2U2D LED send card

Next Job is to set the CON files by LEDStudio, Each RJ45 we can load 400 dots for High,If Overload 400 dots, we use another RJ45 Output..Etc. We start from 1U, THEN 1U-1D-2U-2D.

1).When we Connect the UTP-5 Cable to 1U Output, we SET the Main Cable to 1U

SET the Main Cable to 1U LED send Card

2).When we Connect the UTP-5 Cable to 1D Output, we SET the Main Cable to 1D

SET the Main Cable to 1D LED sending card

3).When we Connect the UTP-5 Cable to 2U Output, we SET the Main Cable to 2U

SET the Main Cable to 2U LED sender card

4).When we Connect the UTP-5 Cable to 2D Output, we SET the Main Cable to 2D

SET the Main Cable to 2D LED sender card
All the setting have to based on your LED Display Connection, After we finish the CON files Setting, we can send it to the led receiving card and save it.
If you have any questions,please contact: linsnled@hotmail.comlinsnled@hotmail.com for Support. If you are looking for TS802D Sending Card and LED Display,please contact: sales@linsnled.com